How to use sandbags to protect your home from flooding

Follow these steps to help reduce the amount floodwater entering your property.

Sandbags correctly placed in appropriate locations around your home or business can reduce the impact of flooding.

They will not stop the water completely but can reduce the amount of water entering your property.

Where do I put the sandbags?

For most buildings, sandbags should be placed over floor wastes and drains (e.g. laundry, shower and bath) to prevent backflow of grey water entering. Sandbags should also be used in front of doorways, roller doors and brickwork vents.

Most standard homes and buildings on a concrete slab can be protected with less than 25 sandbags.

It is not always necessary to place a sandbag wall around your whole building to provide protection.

This may only be necessary if it is on stumps or constructed of materials such as timber or fibro sheeting. 

Before building a sandbag wall, consideration should be given to how you would remove floodwater that could become trapped between the sandbag wall and your building. (e.g. pump, siphon or bailing bucket).

Where can I get sandbags from?

Sandbags can be purchased from some hardware stores or landscaping suppliers. During times of flood and storm, quantities may be distributed by local councils. Contact your local council or visit their website for information.

When significant flooding occurs, sandbags maybe in limited supply and may only be issued by the council or State Emergency Service (SES) on a case-by-case basis. So, be prepared and prepare your own sandbags before a potential flood event.

Self-inflating sandbags (ready-to-use sandbags that don’t require filling) are a lightweight alternative to traditional sandbags. They will self-inflate when they come into contact with water and can be stored a long time. Self-inflating sandbags can be purchased from some hardware stores or landscaping suppliers.

How do I fill the sandbag?

It is preferable that you only use sand to fill the bags. Soil, clay, gravel or a mixture of these is not usually recommended.

Sandbags only need to be filled to two-thirds full.

Do not overfill as they will be too heavy to carry. A filled sandbag can weigh 15-20kg.

Do not tie the top of the bag. The top of the bag may be tied for transport purposes only.

How do I lay sandbags?

Place down a layer of plastic sheeting to act as the water proofing membrane.

Lay sandbags like brickwork on top of the plastic sheeting.

Start at one end and work to the other end.

Ensure the unfilled top part of the bag is covered by the next bag.

Tuck flap under the bag at the end of the row.

Stagger rows so that the joins do not line up.

Where do I place the sandbags?

Place a small sandbag wall across doorways. The number of layers required will be dependent on the expected flood height, however it is generally about two sandbag rows high.

Make sure that you have at least one doorway that you can use to access or exit the building – do this by building a wall that allows the door to still be opened.

Air vents between brickwork may also require sandbags. Small vents may be covered with waterproof tape or plastic.

Cover all drainage holes and floor drains to stop backflow of contaminated water

Protect air vents or drains with sandbags or tape. To avoid back flow of grey water block toilets with a small plastic bag of sand, weighed down by a larger sandbag.

What else can I do to protect my home or business?

Raising valuables off the floor may prevent damage to personal items from floodwater that may still enter.

Lifting of curtains, rugs and bedding, and removing items from low cupboards may be necessary.

Turn off power and gas at the mains.

For other ways to protect your home and family during a flood contact your local council or SES and visit their web sites for further information.

What do I do once I have finished with the sandbags?

Sandbags that have been exposed to floodwater need to be thrown away.

Care should be taken when handling wet sandbags; sturdy gloves should be worn as floodwater can contain chemicals, harmful waste and contaminates.

Sandbags should not be reused if they have been in contact with floodwater.

Sand from used sandbags, not exposed to floodwater or other contaminants can usually be scattered on laws or gardens as topsoil, where it will not wash into stormwater drains.

Contact your local council for advice on how you can dispose of contaminated sandbags.

Click here for more information on sandbagging from the State Emergency Service.